How To Wire A Bathroom Fan And Light On One Switch
Mount the fan close to the light fixture then run the black and white wires from the fan over to the electrical box that feeds the light fixture.
How to wire a bathroom fan and light on one switch. Locate the switch cable which must be glued through the top or side of the box that serves the fan or the light. Switch wiring for bath fan and light electrical question. Connect the white wires the ground wires the black wires and the red wires together. How to wire a bathroom light switch electrical question 1.
Inside the box you ll need to separate the wires to see which feed the fan and which feed the light. Locate the black wires from the bathroom fan and the light. Then remove the lens and light bulb. Shut off the power to the bathroom from the electrical panel.
Connect the power supply wire to the switch. The wiring trick that lets you wire a ceiling fan with light to one switch. That s usually the hot wire for the light. The bathroom also includes an exhaust fan no light two separate switches for light and exhaust fan.
Where do all the wires connect to the light switch. Now for the trick. The new fan is a nutone qtxn110hl. Connect the black fan cable together with the black light wire and the black switch wire and cover them.
Using wire strippers peel an inch of insulation from the end of the black and white wires. Then remove the wire nut on the bundle of black wires and tie the fan s black wire into that. This wiring plan will simply run the fan when the room light is on. The time lag switch will allow the fan to be manually started but then run for a pre set time.
The wall switch box and wiring are already installed and worked with old fan. Connect the two fixture wires to the pigtail by twisting an orange wire nut onto all three wires. The ceiling fan will have a black wire and another non white wire. Connect a light and a fan to a new switch.
Use whichever wire in the box the old light fixture was connected to. Options include a manual pull switch and a vacuum time lag switch. That second wire is usually blue or red. Twist those two wires together then connect them to the black or red wire that came out of your electrical box.
I also had a fan heater light. Twist the pigtail around the top screw on the right side of the wire and tighten the screw. I m replacing a light fixture in a bathroom. Locate the switch cable which should be sticking through the top or side of the box serving the fan or light.
Splice the black wire from the fan together with the black wire from the light and the black wire from the switch and cap them. Enjoy the videos and music you love upload original content and share it all with friends family and the world on youtube. Replace the wire nut. Using wire strippers strip an inch of insulation from the end of the black and white wires.