Dew Point Mold On Bathroom Ceiling

The main cause of mold on a bathroom ceiling is a broken or ineffective exhaust fan.

Dew point mold on bathroom ceiling. To prevent mold from growing in the shower or bath again keep the bathroom ventilated and control moisture as much as possible. Mould is a fungus that grows in damp warm conditions such as a bathroom where there is very little airflow. Run the exhaust fan for at least 30 minutes after a shower or bath. To prevent future mildew infestation make sure your bathroom is properly ventilated.

I recommend replacing the fan with a constant flow unit such as the panasonic whispergreen fan. Matte and other low sheen paints absorb much more moisture which in turn leads to mold growth. If you have mould appearing on your ceilings try this technique to rid it for once and for all. Cleaning mold from the shower or bath can be done with the same methods used on the ceiling.

Once you ve gotten rid of your mildew deposits you ll need to dry the ceiling with the aid of a clean dry cloth. Washing the ceiling regularly is another effective way to prevent mold from growing in the bathroom ceiling. The growth of black mould on bathroom walls and ceilings is due to excess moisture which may start with condensation building up over time following a shower or bath. A simple cleaning solution of water and soap is all that you need to keep the ceiling clean always and make it difficult for mold to grow.

If you see mold growing on your bathroom ceiling it should be treated as soon as possible and removed for health and safety reasons as some mold spores can increase the risk of serious health problems. Wash all bathroom surfaces floors ceilings walls and fixtures in a solution of 1 cup of borax to a gallon of water. It can be caused by the warm temperature of the room the humidity from baths and showers low levels of natural light and poor air circulation. It can start as mildew a white form of fungus found on a flat surface.

Clean the area with a household bathroom cleaner first then use either a bleach solution or vinegar to kill the mold. Agitate the water to get all the borax dissolved and wash down everything. Moisture and dampness are among the leading causes of mildew formation so when performing this step be as thorough as possible. If that s outside of your budget you can install a timer switch on the existing fan.

Firstly find out why it might be happening it could be from. Here is a link.